Flame is an extremely versatile distortion unit capable of anything from mild tube overdrive to nasty bit crushing and radical fuzzbox effects. The Driver has many different types of waveshaping types and the unique structure of not only pre/post gain, but pre and post filtering with mixable LP/HP filters on each side of the Drive circuit. All of which makes for a killer distortion processor!

MINI-SLIDER

Controls the mix of the dry signal and the processed (Wet) signal. The percentage indicated is the amount of the signal that is Wet. Range: 0 to 100%Wet

[PRE] GAIN

Adjusts the amount of gain BEFORE being processed by the Flame Driver. Range: -200 to +10 dB

[PRE] TYPE

Adjusts the balance of two filter types applied to the audio BEFORE being processed by the Driver.

Range: 100% Low Pass to 100% High Pass.

[PRE] FILTER

Controls the Cutoff Frequency of the Filter. Range: 100 to 21924.17 Hz

DRIVER

Drop-down menu with different waveshaping drive options.

Choices: Warm, Heat, BURN, Fuzzy, Scorch, Loud, Glow, Roast, Toast, 2 Bits, Torch, Bake, Ignite, Gater, Psycho, Cook, Blaze, Smoke, MELT, Topkill, Tube, Valve

CAUTION: Some of these drivers can produce extremely loud sounds, so watch out!

[POST] GAIN

Adjusts the amount of gain AFTER being processed by the Flame Driver. Range: -200 to +10 dB

[POST] TYPE

Adjusts the balance of two filter types applied to the audio AFTER being processed by the Driver.

Range: 100% Low Pass to 100% High Pass.

[POST] FILTER

Controls the Frequency of the Filter. Range: 100 to 21924.17 Hz