The primary function of the filter is to remove, hence “cut off,” frequencies from the sound. Omnisphere’s filters can remove frequencies in a variety of ways, from Lowpass, Highpass, Bandpass, Notch to more specialized filter types. Depending what Filter preset is chosen, the Cutoff control will remove different frequencies in various ways.
For example, if a Lowpass filter is used, turning the control counter-clockwise will remove the higher frequencies. If a Highpass Filter is used, the opposite will happen. It’s best to experiment with cutoff control with the wide variety of Filter Types.
The Filter’s roll off slope is measured in dB, and is sometimes expressed in “poles.” The higher the dB value, the greater the extent of the filtering, but this should not be confused with sounding “better.” Filters with fewer poles can often sound more appropriate than those with more poles.
|6dB =||1 Pole|
|12dB =||2 Pole|
|18dB =||3 Pole|
|24dB =||4 Pole|
Range 00.05Hz to 19.00kHz
Omnisphere has many specialized filters, some of which are based on tuned delay lines (e.g. Metal Pipe +/- and Resonator +/-). In those cases, the Cutoff is used to tune the filter’s pitch.