Flex-Mod

Flex-Mod is the quickest way to set up a Modulation Routing. By right-clicking on the control to be modulated, you’ll get a pop-up menu from which you can select “Modulate” and then select from the list of available Sources.

The first group of modulation options in the list is commonly used Sources. If there’s more than one Source available of a given type, the first available will be used automatically.

For example, when “Modulate with LFO” is selected, the first available LFO will automatically be routed to the Target Parameter. If LFO1 is being used elsewhere as a Modulation Source, the Flex-Mod system will automatically assign LFO2. Any of these automatic routings can be overridden as well.

A complete list of all the Modulation Sources is provided at the bottom of the menu as “All Mod Sources,” so specific sources can be chosen if that’s preferred.

NOTE: Not all controls are modulatable, but the majority are.

After the Target Parameter’s Modulation Source has been selected, the routing is then displayed in the MODULATION section of the LAYER page.

NOTE: If all eight LFOs have been routed as Modulation Sources and “Modulate with LFO” is selected, new routings will default to LFO1. This is the same with the Modulation Envelopes—when all four are in use, any additional “Modulate with Envelope” routings will default to MOD Envelope 1.