Omnisphere HW

Setting up the MS-2000

Setup

To control Omnisphere using the Korg MS2000, you’ll need to do the following:

  • Connect the MS2000 to your MIDI interface.

  • Set up the MS2000’s front panel controls to send MIDI.

  • Activate the Korg MS2000 Hardware Profile in Omnisphere 2.6 or higher.

MIDI OUTPUT SETUP

  • Select the MS2000’s GLOBAL button.

  • Press the PAGE + button until the display reads “MIDI FILTER.”

  • Press the right CURSOR button until the display reads “MIDI FILTER CtrlChg:”
  • Make sure that “CtrlChg:” is set to “ENA” (to enable CC & NRPN messages).


HOST CONNECTION

Open your host (DAW, Standalone, etc.) and make sure the MIDI interface you’ve connected the MS2000 to is enabled as a MIDI input device.
Omnisphere Standalone Pro Tools

OMNISPHERE SETUP

Open Omnisphere and from the header, select the HW menu button:

From the drop-down menu, select “Korg>Korg MS2000” to activate that hardware profile.

Unassigned Controls

The following MS2000 controls have no effect on Omnisphere:

  • VOLUME
  • TIMBRE SELECT
  • AUDIO IN 1/2
  • SEQ EDIT/CH PARAM Section
  • MOD SEQUENCE Section

Troubleshooting

Not working? Here are some things to try:

  • Is the front panel of the MS2000 properly set up to send CCs? (see MIDI OUTPUT SETUP above.)
  • Is your DAW receiving MIDI from the MS-2000?
  • If you are using the Omnisphere standalone host, make sure the MIDI output channel of the MS-2000 matches the MIDI channel of the Omnisphere Part you want to control.
  • Make sure your DAW is configured to correctly route the MIDI output of the MS-2000 to the MIDI channel assigned to the desired Part in Omnisphere.

SUPPORT

Still not working? More questions? 

Feel free to contact us directly and we can work with you: 

Tech Support 
888-870-4223 toll free 
818-955-8444 
Monday – Friday 10AM – 5PM Pacific Time 
email: info@spectrasonics.net