Flame

FLAME is an extremely versatile distortion unit capable of anything from mild tube overdrive to nasty bit-crushing and radical fuzzbox effects. The Driver has many different types of waveshaping types and the unique structure of not only pre/post gain, but pre and post filtering with mixable LP / HP filters on each side of the Drive circuit—all of which makes for a killer distortion processor!

MINI-SLIDER
Controls the mix of the dry signal and the processed (Wet) signal. The percentage indicated is the amount of the signal that is Wet.
Range: 0 ~ 100% Wet

• PRE GAIN
  Adjusts the amount of gain BEFORE being processed by the Flame Driver.
  Range: -200 ~ +10 dB

• PRE TYPE
  Adjusts the balance of two filter types applied to the audio BEFORE being processed by the Driver.
  Range: 100% Low Pass ~ 100% High Pass

• PRE FILTER
  Controls the Cutoff Frequency of the Filter.
  Range: 100 ~ 21924.17 Hz

• DRIVER
  Drop-down menu with different waveshaping drive options.
  Choices: Warm, Heat, Burn, Fuzzy, Scorch, Loud, Glow, Roast, Toast, 2 Bits, Torch, Bake, Ignite, Gater, Psycho, Cook, Blaze, Smoke, Melt, Topkill, Tube, Valve

!CAUTION: Some of these drivers can produce extremely loud sounds, so watch out!

• POST GAIN
  Adjusts the amount of gain AFTER being processed by the Flame Driver.
  Range: -200 ~ +10 dB

• POST TYPE
  Adjusts the balance of two filter types applied to the audio AFTER being processed by the Driver.
  Range: 100% Low Pass ~ 100% High Pass

• POST FILTER
  Controls the Frequency of the Filter.
  Range: 100 ~ 21924.17 Hz