Multis

A set of images can be shared by an entire library of Multis, by a Category, or used by a single Multi.

Adding Images to a Multi Library

A set of images can be shared by all the Multis in a library. You will need two .jpg files with the following naming convention and dimensions:

• Multi Name.jpg [300w x 300h] or [600w x 600h]
• Multi Name_thumb.jpg [125w x 125h] or [250w x 250h]

Place the .jpg files inside the Multi library folder here:

• Spectrasonics/STEAM/Trilian/Settings Library/Multis/Library Name

As shown in the screenshot below, images are used by all the Multis in “My Stage Basses.”

NOTE: Categories or Multis that have unique images assigned to them will take precedence over the Library image.

Adding Images to a Multi Category

A set of images can be shared by all the Multis in a Category. You will need two .jpg files with the following naming convention and dimensions:

• Multi Name.jpg [300w x 300h] or [600w x 600h]
• Multi Name_thumb.jpg [125w x 125h] or [250w x 250h]

Place the .jpg files inside the Multi Category to which you want to add images, using this path:

• Spectrasonics/STEAM/Trilian/Settings Library/Multis/Library Name/Category

As shown in the screenshot below, images are used by all the Multis in the “Latch Arps” category.

NOTE: Multis that have unique images assigned to them will take precedence over the Category or Library images.

Adding Images to a Multi

To add images to a Multi, you will need two .jpg files with the following naming convention and dimensions (replace “Multi Name” with the name of the Multi):

• Multi Name.jpg [300w x 300h] or [600w x 600h]
• Multi Name_thumb.jpg [125w x 125h] or [250w x 250h]

Place the .jpg files next to the Multi to which you want to add images (Multi files have .mlt_omn extensions) following this path:

• Spectrasonics/STEAM/Trilian/Settings Library/Multis/Library Name/Category

As shown in the screenshot below, images are used by the Multi “Lowdowntempo.”