FX - Smoke Amp Simulator
The Smoke Amp Simulator
has a full set of amplifier controls, speaker combinations and modeled versions
of several classic guitar amplifiers.
• PAGE ONE CONTROLS
(AMP)
AMP
Enables or disables the
amplifier model. If the switch is
off, then none of the amplifier models will be active (although the Speaker,
Gain, Drive and Master controls will still be operational).
MODEL
These are
representations, or models, of well-known guitar amplifiers;
USA – Fender™ Deluxe
Plexi – Marshall™ Plexi
British – VOX™ AC-30
Chief – Matchless™ Chieftain
Rectify – Mesa Boogie™ Rectifier
Twin – American Fender Twin ™
MIC
This is a switch to
control on-axis versus off-axis micing of the speakers.
SPEAKER
There are three
different algorithms that simulate the number of speaker cones in an amplifier
housing. If OFF is chosen, no
speaker modeling will be heard.
1X12
– one active 12-inch speaker
2X12
– two active 12-inch speakers
4X12
– four active 12-inch speakers
GAIN
The Gain switch
introduces a XXdB boost into the guitar amp, like a “High Gain” switch.
DRIVE
Sometimes referred to as
Overdrive, Drive represents the amount of overloading of the amplifier –
which is what creates distortion. The higher this control is set, the more distorted the signal will be.
Range: 0-100
MASTER
This is the output level
of the amplifier. When set to a
minimum setting, no signal will be heard. Range: 0-100
• PAGE TWO CONTROLS
(TONE)
TONE
This switch enables the
four tone controls. When turned
off, the settings of the Bass, Mid, Treble and Presence are disabled.
BASS
Controls the amount of
low frequencies. Range: 0-100
MID
Controls the amount of
mid-range frequencies. Range: 0-100
TREBLE
Controls the amount of
high frequencies. Range: 0-100
PRESENCE
Sometimes referred to as
Brilliance or Edge, Presence boosts very high frequencies. Range: 0-100
