STACK MODE - Adding & Removing Parts

 

 

To add a Part, Right/Control-Click on the desired Row in the Stack Mode Grid, then choose a Part from the menu.  All of the Patches loaded into the current Multi will appear in this menu.  Any unassigned Parts will display as “----------“.

 

NOTE: You can add Parts to the Stack Mode Grid that have no Patches loaded yet.

 

To place two (or more) Parts on the same Row simply Right/Control-Click on a Row again, and select “Add Part” for each Part that you want to add to that Row. Up to 8 Parts can be added to a single Row, however it is usually simplest to assign each Part to its own corresponding Row.

To remove a Part from any Row, Right/Control-Click on the Region and select “Remove this Part”.

 

NOTE: Removing a Part from the STACK MODE grid doesn’t remove that Part from the Multi, so it can be added back to the grid again if desired. When re-adding a Part, all previous changes made to its Region (position, width and fades) are retained when added back to the grid.