EDIT PAGE - Effects Modulation

 

 

 
The fact that Omnisphere can modulate nearly fifty synthesis parameters is only part of the story. Any of Omnisphere’s modulation sources can be applied to the myriad of FX parameters as well. Just about every single parameter in all of Omnisphere’s 33 effects modules can be modulated, which means there are over 200 effects parameters available on top of all of the synthesis parameters. In total, Omnisphere has nearly 300 available modulation targets!

Effects Modulation can be set up quickly using the same flex-mod system available on the MAIN and EDIT pages.

 
Modulation Effects Menu

Any effect that’s added to a Layer Effect rack (A or B) is available as a modulation target. After any Effect has been added to a Layer rack, a new category called “Layer Effects” will appear at the bottom of the list of target categories.

 
NOTE: Only FX assigned to a Layer Rack are available as Modulation Targets - FX in the COMMON rack are not.

 
When any modulatable parameter is right-clicked, the same list of Modulation options appears when a synthesis parameter is right-clicked. All of the Modulation options are the same.

 

 

After a parameter has been assigned as a Modulation Target, the control will become shaded with a bluish tint (in the example below, the Delay control is now blue).

 

 

These parameters will be available as long as the effect module is assigned to the Patch – meaning they will no longer appear if they effect is removed from that Layer’s rack.