EDIT PAGE – Wave Shaper - Mix, Path and Gain

 

 

MIX

The MIX slider controls the balance between the original Oscillator’s signal and the Wave-Shaped sound.  If the mix is at the minimum setting, then the effect of the Wave Shaper is not heard.  When set to the maximum, only the Wave-Shaped signal is heard.

MIX is modulatable.

Range 0.000 to 1.000

 

AUDIO PATH

These three mode switches determine at what point in Omnisphere’s audio path that the Wave Shaper is placed.  It can be placed after the Oscillator, the Filter or the Amplifier;

OSC (Oscillator) - The Wave Shaper is placed after the Oscillator output, before the Filter section.

FILTER (Filter) - The Wave Shaper is placed after the Filter’s output, before the Amplifier.

AMP (Amplifier) - The Wave Shaper is placed after Omnisphere’s Amplifier.

 

GAIN

The GAIN slider controls the amount of gain that is applied to the output. 

Range 0.000 to 1.000