EDIT PAGE – Oscillator Voice Multiplier - Harmonia™Zoom - Synth Controls

 

.

 

When the OSCILLATOR is set to SYNTH mode, all of the HARMONIA features in SAMPLE mode are available, as well as a second set of options that are unique to SYNTH mode. This special set of controls allows independent waveform control over each HARMONIA voice.

 

HARMONIA PHASE

Like the Phase Control option in UNISON, this is unique to the SYNTH Oscillators.  The Phase Control allows the phase of the HARMONIA voices to be spread across a 180° range. The width of the range is controlled by stepping through the five Phase Control options, which range from In-Phase to totally Out-of-Phase.

 

 

HARMONIA SHAPE

This control is unique to SYNTH Oscillators. This is an offset of the SHAPE control on the MAIN OSCILLATOR page. Each of HARMONIA’s four voices can have its own SHAPE offset. The center position indicates that the HARMONIA voice's SHAPE is identical to the main Synth Oscillator's SHAPE. 

 

NOTE: To learn more about the SHAPE functionality, check out the description in the OSC MAIN chapter.

 

Range 0.000 to 1.000

 

HARMONIA SYMMETRY

This control is unique to SYNTH Oscillators. This is an offset of the SYMMETRY control on the MAIN OSCILLATOR page. Each of HARMONIA’s four voices can have its own SYMMETRY offset. The center position indicates that the HARMONIA voice's SYMMETRY is identical to the main Synth Oscillator's SYMMETRY. 

 

NOTE: To learn more about the SYMMETRY functionality, check out the description in the OSC SYMMETRY chapter.

 

Range 0.000 to 1.000

 

HARMONIA SYNC

This control is unique to SYNTH Oscillators. This is an offset of the HARD SYNC control on the MAIN OSCILLATOR page. Each of HARMONIA’s four voices can have its own SYNC offset. The center position indicates that the HARMONIA voice's SYNC is identical to the main Synth Oscillator's HARD SYNC. 

 

NOTE: To learn more about the HARD SYNC functionality, check out the description in the OSC HARD SYNC chapter

 

Range 0.000 to 1.000

 

HARMONIA WAVESHAPE

This control is unique to SYNTH Oscillators. The waveshape of each of the four HARMONIA voices can be set from these steppers. Four of the waveshapes are the same as those available in the Waveform Selector in OSC MAIN: Triangle, Sine, SawSquare Bright & SawSquare Fat. The fifth waveshape, called OSC, means the HARMONIA waveform will follow the primary Oscillator’s current waveform selection.

 

	Triangle
	Sine
	OSC
	SawSquare Fat
	SawSquare Bright

 

NOTE: To learn more about the SYNTH WAVESHAPE functionality, refer to the OSC SHAPE chapter