FLAME is an extremely versatile distortion unit capable of anything from mild tube overdrive to nasty bit-crushing and radical fuzzbox effects. The Driver has many different types of waveshaping and the unique structure of not only pre / post gain, but pre / post filtering with mixable LP / HP filters on each side of the Drive circuit.

MINI-SLIDER
Controls the mix of the dry signal and the processed (Wet) signal. The percentage indicated is the amount of the signal that is Wet. Range: 0 to 100% Wet

  • PRE GAIN
    Adjusts the amount of gain BEFORE being processed by the Flame Driver.
    Range: -200 to +10 dB
  • PRE TYPE
    Adjusts the balance of the two filter types applied to the audio BEFORE being processed by the Driver.
    Range: 100% Low Pass to 100% High Pass
  • PRE FILTER
    Controls the Cutoff Frequency of the Filter.
    Range: 100 to 21924.17 Hz
  • DRIVER
    Drop-down menu with different waveshaping drive options.
    Choices: Warm, Heat, Burn, Fuzzy, Scorch, Loud, Glow, Roast, Toast, 2 Bits, Torch, Bake, Ignite, Gater, Psycho, Cook, Blaze, Smoke, Melt, Topkill, Tube, Valve
  • POST GAIN
    Adjusts the amount of gain AFTER being processed by the Flame Driver.
    Range: -200 to +10 dB
  • POST TYPE
    Adjusts the balance of the two filter types applied to the audio AFTER being processed by the Driver.
    Range: 100% Low Pass to 100% High Pass
  • POST FILTER
    Controls the Frequency of the Filter.
    Range: 100 to 21924.17 Hz