Retro Phaser

Retro Phaser has a vintage, low-fi vibe. On the surface it looks similar to the EZ Phaser, but has more features and a dedicated page for tone-shaping.

MINI-SLIDER
Controls the mix of the dry signal and the processed (Wet) signal. The percentage indicated is the amount of the signal that is Wet.
Range: 0 to 100%

PAGE ONE CONTROLS

• RATE
  Controls how fast the LFO cycles. The value of the Rate control is determined by the Sync control. If Sync is engaged, then the vales of Rate will be in musical values. If Sync is not engaged, Rate’s values will be in Hz.
  Range:
  Synced: 32x,16x, 8x, 7x, 6x, 5x, 4x, 3x, 2x, 1/1, 1/2, 1/4, 1/8, 1/16, 1/32, 1/64, 1/96, 1/1dot, 1/2dot, 1/4dot, 1/8dot, 1/16dot, 1/1triplet, 1/2triplet, 1/4triplet, 1/8triplet, 1/16triplet
  Unsynced: 0.00Hz to 15.00 Hz

• DEPTH
  Controls the sweep range of the modulation.
  Range: 0 to 1

• SYNC
  Engages and disengages synchronization of the LFO rate with the host’s tempo.

• POLES
  Drop-down menu that selects how many stages or “poles” used by the Phaser. More poles equal a more resonant sound character.
  Range: 4, 6, 8, or 12 poles

• MANUAL
  Controls the center point of the Phaser.
  Range: 0 to 100%

• FEEDBACK
  Controls the amount of resonance / feedback of the Phaser. High settings will oscillate.
  Range: 0 to 100%

• INVERT
  Changes the phase angle of the Phaser by 180º, changing the tone character of the phasing.

PAGE TWO CONTROLS

• DIRT
  Adds subtle overdrive to the Phaser’s signal.

• TONE
  This control is a simple tone control.
  Range: Dark to Bright

• TONE FX
  Applies the Tone setting to either both the wet and dry signals, or just the wet signal.
  Range: WET / DRY or WET

• WIDTH
  Controls the width of the stereo image.
  Range: 0 to 100%

• LEVEL
  Adjusts the overall output.
  Range: 0 to 13.0 dB