Setup
To control Omnisphere using the Sirin you’ll need to do the following:
- Connect the Sirin’s USB connector to your computer.
- Set the Sirin’s Decay/Release Mode to “Mode 2.”
- Activate the Moog Sirin Hardware Profile in Omnisphere 2.6 or higher.
RELEASE MODE SETUP
Set the Release Mode 2 by pressing and holding the RELEASE ON/OFF switch for 1 second. The RELEASE switch LED will blink one time to indicate Mode 1, or two times to indicate Mode 2.
HOST CONNECTION
Open your host (DAW, Standalone, etc.) and make sure the Moog Sirin is enabled as a MIDI input device.
 |
 |
| Omnisphere Standalone | Pro Tools |
OMNISPHERE SETUP
Open Omnisphere and from the header, select the HW menu button:
From the drop-down menu, select “Moog>Moog Sirin” to activate that hardware profile.
Unassigned Controls
The following Sirin controls have no effect on Omnisphere:
- Volume
- Fine Tune
Troubleshooting
Not working? Here are some things to try:
- Is your DAW receiving MIDI from the Sirin?
- If you are using the Omnisphere standalone host, make sure the MIDI output channel of the Sirin matches the MIDI channel of the Omnisphere Part you want to control.
- Make sure your DAW is configured to correctly route the MIDI output of the Sirin to the MIDI channel assigned to the desired Part in Omnisphere.
SUPPORT
Still not working? More questions?
Feel free to contact us directly and we can work with you:
Tech Support
888-870-4223 toll free
818-955-8444
Monday – Friday 10AM – 5PM Pacific Time
email: info@spectrasonics.net
